常見例句

• The calculation formula of DSIF was proposed.
  在此基礎上,構建了用于計算動態應力強度因子的近似表達式。
• The dynamic stress intensity factor (DSIF) at the terminating point is defined in terms of the singular stresses at the point.
  利用所得的奇性應力定義了裂紋和界面接觸點處的動應力強度因子。
• The distributions of DSIF with time under different pavement temperature field are similar,and the maximum DSIF decreased with increasing temperature.
  不同溫度下的最大動應力強度因子出現的時間基本相同,且最大動應力強度因子隨溫度的升高而減小;
• The solution of DSIF at crack tips is obtained. The method of crack-division is used to make radial cracks at the edge of cavity.
  采用裂紋切割技術構造出孔邊徑向裂紋，利用哈爾濱工程大學博士學位論文Green函數建立直接求解m型裂紋尖端動應力強度因子的定解積分方程組。
• Based on the problems,software of information fusion based on D-S evidence theory(DSIF) is designed and developed in the paper.
  針對這些問題,本文設計、開發了基于D-S證據理論的信息融合計算分析軟件(DSIF)。
• Last when the medium parameters are altered, the influence on the crack DSIF is discussed partially with the displacement between circle canyon and crack.
  最后討論了當介質參數不同時 ,隨著圓孔與裂紋的距離變化對裂紋尖端動應力因子的影響
返回 DSIF