fracture strength

基本解釋

Methods 15 anterior ceramometal test full crowns were fabricated and 15 natural anterior teeth were selected. Fracture strength were measured.
制作15個前牙金瓷全冠，挑選15個離體前牙，測定其折裂時的強度。
Yield strength of in-situ MMCs is 28% and 95.7% higher, respectively than those of ex-situ MMCs and matrix aluminum, and fracture strength is increased by 20.6% and 88.5% correspondingly.
原位復合材料的增強效果明顯，屈服強度比外加復合材料和基體分別高出28%和95.7%，斷裂強度則相應提高了20.6%和88.5%；
The experimental results show that the fracture strength and strain first increase and then decrease with increasing the Ti content, and reaching the maximum value when Ti content is 5 at. %.
試驗結果表明，隨Ti含量增加，合金的斷裂強度及斷裂應變先增后降，在Ti含量為5at。%時達到最大值。

斷裂強度
Compressed fracture strength increases from 467MPa to 580MPa, and fracture strain increases from 5.2% to 8.7% with increasing the Fe content from 0 to 7 at.
Fe含量從0 at.%增至7 at.%時,壓縮斷裂強度由467MPa增至580MPa,斷裂應變由5.2%增至8.7%。
醫藥科學
斷裂強度
The properties of these materials are highly dependent on the skills of the dental technicians. In addition, process-dependent microdefects reduce the fracture strength and increase the time-dependent failure probability of restorations.
傳統的全瓷修復體通常是采用注漿成型、失蠟鑄造或熱壓預先晶化的玻璃等方法制作的，采用這些方法所制作的修復體的質量，在很大程度上取決于牙科技師的個人技術，此外，在加工過程中所造成的微缺陷也降低了陶瓷材料的斷裂強度，增加了修復體失敗的幾率。
機械工程
斷裂強力
It later gives out the conclusion that both the fracture strength and hairiness meet with the requirement of warp knitting according to the test and theoretical calculation.
根據實際測量和理論計算,得出緊密紡高支棉紗的毛羽量和斷裂強力均符合經編工藝的基本要求。
物理學
斷裂強度
抗斷強度
破裂強度